How to wire a plug?

If you are researching how to wire a plug? So, you are at the right place. We will help and guide you on how to use a wire plugin perfectly and safely. Before working on any electrical circuit, you must know if it is isolated correctly or not. So don’t stop reading this post before starting any electrical work.

However, to wire a plug, you need to strip each cable to the bare wire. After stripping, connect the red (L) wire to the live terminal of the plug, neutral or blue to the neutral terminal, and finally the green or yellow to the earth terminal of the pin.

Stripping wires can be tricky, so we will show you some essential tools and materials required to fix any wire or cable in this article.

How to wire a plug correctly.

Before plugging a wire, first of all, keep in mind that turn off the power circuit at the main electrical panel by removing the fuse, then start working on it. Although you can strip practically any wire with just a blade, it will be better to use a wire stripper for safety reasons. If you intend to do home improvements or your home fixes, a wire stripper is moderate and easy to use, and they produce safe results.

Most electrical things come with a fitted plug now. However, you need to wire a fitting. Here are the guidelines. There are three pins in the plug, yet once in a while, just two of these are utilized on twofold protected electrical things.

Tools and Materials required

Tools

• 4 in 1 screwdriver
• Drywall saw
• Voltage tester
• Needle nose Pliers
• Wirecutter

Materials

• Electrical wire
• Wire connector
• Receptacle
• Remodeling box

Steps of wire plugging

You can quickly fix the faulty electrical wall without the help of a professional electrician if you follow the following steps correctly,

Remove the plastic outer sheath of the power cord.
Shorten the live wire
Remove the inner insulation from the inside cores
Twist the strands and double theme over
Loosen the screws on the cable grip
Choosing a snips
Attached is the brown wire into the L (live) terminal
Connect the green or yellow wire with the E (Earth) terminal and make sure the cables caught by the screw
Once you are done with all steps, connect the blue wire to the Neutral (N) terminal
Tight the strain relief and replace the cover

Turn on the main power

After plugging a wire, check the fuse in a plug is okay and fix it correctly by turning on the main power back. For testing the plug, use the voltage checker and don’t use any other item to check it.
If you plug any wire according to the steps mentioned above, you can fix any wire at your home quickly. You can do it without any required professional electrician. I hope this article will be helpful to you, and after reading this page, you can do it correctly and safely.

Also read: How to open a coconut.